bimai
Using bimai

SCIA Engineer bridge

Let a constructeur's team read calculation results from SCIA Engineer, read-only. Beta.

Beta

Built and installable, but not yet verified inside the real program. Built from SCIA's own OpenAPI examples. Please report what works.

For the constructeur (structural engineer), bimai's team gets a Structural Analyst that reads the results of your SCIA Engineer calculation and explains them with the numbers:

"What is the largest bending moment in beam B3 for CO1?" "How much does slab S1 deflect in load case LC2?" "What are the reactions at support Sn1?"

It never changes your model: the bridge opens a copy of your .esa file and closes it without saving.

What it can read

ToolWhat it gives
open_projectopens a copy of a .esa file in your project folder (the only one, or the one you name)
get_member_resultsinternal forces, deformations or relative deformations along a member, per section, with the extremes
get_surface_resultsinternal forces, deformations, stresses, strains or contact stresses of a slab or wall: minimum and maximum per magnitude
get_support_reactionsthe reactions of a point support
run_calculationa linear calculation of the copy when your project has no results yet (your team asks you first)

Use the names as SCIA shows them: members (B3), surfaces (S1), supports (Sn1), load cases (LC1) and combinations (CO1). Values are in the units of SCIA's result API (SI); the Structural Analyst says so.

Set it up

You need Windows and SCIA Engineer 21 or newer with a license; SCIA's OpenAPI comes with it. In your project folder:

bimai init          # choose "Constructeur"; a folder with .esa files suggests it
bimai connect scia  # if you didn't choose SCIA Engineer during onboarding
bimai scia status   # which SCIA Engineer bimai found

Nothing to install: bimai loads SCIA's OpenAPI from your SCIA installation when your team first asks for a result. That starts a SCIA Engineer of its own in the background (not your open window); it closes when the Claude Code session ends.

How it works

SCIA Engineer's OpenAPI starts its own SCIA Engineer and opens a project file; it can't look into the window you have open. So when your team asks:

  1. bimai copies your .esa file to a temporary folder,
  2. starts SCIA Engineer in the background and opens the copy,
  3. reads the results you asked for, and later closes the copy without saving.

If your file has changed since, ask your team to open it again: it then reads a fresh copy. Save your project in SCIA first, so the copy includes your latest results.

Beta: help us verify it

The bridge follows SCIA's own OpenAPI examples, but nobody has run it with SCIA Engineer yet. If you are a constructeur with SCIA, this takes about 15 minutes:

  1. Install bimai (see Install) and run bimai scia status: does it find your SCIA?
  2. In a folder with a calculated .esa project: bimai init (Constructeur, Structural results, SCIA Engineer).
  3. Start a new Claude Code session and ask, with names from your model:
    • "Open the SCIA project and give the internal forces in member B1 for load case LC1."
    • "What is the maximum deflection of slab S1 in LC1?"
    • "Give the reactions of support Sn1 in LC1."
  4. Compare the numbers with SCIA's own results tables. Are the units what you expect?
  5. Report what you found in a GitHub issue, with your SCIA version and the bridge log (%TEMP%\bimai-scia.log). Remove anything confidential first.

On this page